Forced to replace injured player, then forced to replace the replacement

[randcoop]

Christian Yelich hurt sliding into the base. I am forced to replace him immediately, even though he’s out on the slide. But when I replace him with Taylor, Taylor is identified as PR/RF…he can’t have been a pinch-runner, since Yelich was out. And then, at the end of the inning, I’m forced to replace Taylor…he’s not allowed to play the outfield?!? This is a serious flaw, since it requires me to use two players on the roster for a single injured player.

[RandySteinman]

This is just a guess… But I’m thinking maybe all you needed to do at the end of the inning was then click on which position Taylor was to play in the field.
I’ve been prompted to do that before with substitute players. But don’t remember the new player needing to be entirely replaced again…

[randcoop]

You may be right. It looked to me like the position was un-clickable, but I didn’t try. I will if/when it happens again. Thanks.

[anluc7]

@randcoop it’s a glitch just hit the x when the roster pops up again and it will be ok. At the end of the inning just put that player in his position. It will say you replaced him with him. Clear as mud?

[falcon4fever]

This happened to me a game yesterday as well…will try it out next time it happens

[randcoop]

@anluc7

I will give that a try next time. In any event, you’ve just given me a good tip: hit the x? Didn’t know that would do anything.

Thanks